title

Showing posts with label mold. Show all posts
Showing posts with label mold. Show all posts

Friday, March 25, 2022

Mold_02

Second attempt at making a mold. Had a scale this time, but still i can't seem to get the measurements right. Had way too much in the first side of the mold and barely enough on the other side.

The first cast of the silicone was a failure. I applied a thin layer on each side of the mold with some extra around the endges to hopefully connect it. It cured for 12 hours, where I for the first few constantly shifted it around to make sure it didn't all gather in the bottom. This ended up happening either way. There was a thin layer around the whole thing. But it just collapsed on itself when i opened it. The silicone was also super sticky as I probably opened it too early.

Problem with this one is that it will be hard to keep the model in the center. Also i think maybe the silicone wall will be too thick. Another problem is that the silicone is super sticky, as a result getting it off from the mold and object will be difficult.

Tuesday, March 22, 2022

Mold_01

I remember last time that the motors where not strong enough to pull it. This may be partly cause of the motor itself but also partly cause of the spool was made out of plywood. I guess a servo motor would be a better choice.

I can buy a 30x30 aquarium, however should i maybe make one instead? Making would give me more choice in terms of how to place motors / sensors?

This first mold was a failure. I thought I would start with a simple model, similar to the one from the previous experiment, just to try making a mold. The clay model ended up cracking. Also i had way too much space around the object, should probably limit it to two - three cm. I did not have a scale so I ended up eye balling the measurements for the plaster and ended up with too little, not enough to cover the model.